ÖÕÓÚ°ÑdynamipsÉÏÃæ»®vlan¸ø¸ã¶¨ÁË£¬ÂÅÊÔ²»Ë¬£¬»¹ÄÜÔÚÄ£ÄâµÄÈý²ã½»»»»úÉÏÆðtrunkºÍsvi¡£
ÏÈÊÇÔÚR7£¬ÔÀ´µÄfr½»»»»úÉϼÓÒ»¿éPA-8EµÄ°å×Ó£¬È»ºó·Ö×éÇŽӣ¬ÅäÖÃÉÏBVIºÍ¶à¸öÇŽÓ×é¡£
ÏëtrunkÒ²²»ÄÑ£¬vlan iDÒ²¿ÉÒÔ¶©ÖÆ¡£
IF:interface_name:netio_type[:netio_parameters]
1) Configuring an Access Port
syntax: ACCESS:interface_name:vlan_id
2) Configuration a 802.1Q Trunk Port
syntax: DOT1Q:interface_name:native_vlan
The native VLAN is not tagged. On Cisco devices, by default the native VLAN
is VLAN 1.
Example of configuration file:
IF:E0:udp:10000:127.0.0.1:10001
IF:E1:udp:10002:127.0.0.1:10003
IF:E2:gen_eth:eth0
DOT1Q:E0:1
ACCESS:E1:4
DOT1Q:E2:1
ÕâÑù£¬ÎÒR7Ò²³ÉÁËһ̨Èý²ãÉ豸¡£topµÄÁé»î³Ì¶ÈÓÖÌá¸ßÁË¡£
16 Ethernet interfaces
2 FastEthernet interfaces
8 Serial interfaces
125K bytes of NVRAM.
²Î¿¼ÎÄÏ×£¬cisco document :Configuring Transparent Bridging
dynamips readme.txt
| ×ÔÓÉ¹ã¸æÇø |
| ¡¡ |